ISSN 0021-3454 (print version)
ISSN 2500-0381 (online version)
Menu

11
Issue
vol 61 / NOVEMBER, 2018
Article

DOI 10.17586/0021-3454-2018-61-6-549-551

UDC 621.924.93

INVESTIGATION OF TECHNOLOGY OF GEAR CROWNS MANUFACTURING USING ABRASIVE WATER JET EQUIPMENT

V. M. Medunetskiy
ITMO University, Saint Petersburg, 197101, Russian Federation; Professor


P. A. Nikolaev
JSC „Rawenstvo“; Process Engineer


Read the full article 

Abstract. The possibility of using waterjet cutting equipment for gear crowns manufacturing is considered. According to performed investigations, water-jet cutting with NC3015S equipment can replace only the roughing. Results of measurements of crowns working surfaces are presented and the accuracy of manufacturing is evaluated.
Keywords: ring gear cutting, hydro-abrasive cutting, roughness parameters, surface microgeometry

References:
  1. KalashnikovS.N., KalashnikovA.S., KoganG.I. еtal. Proizvodstvo zubchatykh koles: Spravochnik(Production of Cogwheels: Reference Book), Moscow, 1990, 464 р. (in Russ.)
  2. Tikhonov A.A. Povyshenie effektivnosti protsessa gidroabrazivnoy obrabotki (Increase in Efficiency of Process of Hydroabrasive Processing), Candidate’s thesis, Rostov-na-Donu, 2011, 157 р. (in Russ.)
  3. Balashov O.E., Barzov A.A., Galinovskiy A.L. еt al. Ul'trastruynaya tekhnologiya polucheniya mikrosuspenziy (Ultrajet Technology of Receiving Microsuspensions), Bauman Moscow State Technical University, 2011, 352 р. (in Russ.)