ISSN 0021-3454 (print version)
ISSN 2500-0381 (online version)
Menu

2
Issue
vol 67 / February, 2024
Article

DOI 10.17586/0021-3454-2015-58-4-315-317

UDC 621.91.01

METHODS OF DETERMINING THE CUTTING FORCES ARISING IN THE ACT OF WORKPIECE PROCESSING

R. M. Isaev
JSC „Tehpribor“, ITMO University, Department of Instrumentation Technology; Engineer; Post-Graduate Student


A. V. Lubiviy
JSC „KGFI“; ITMO University, Department of Instrumentation Technology;; Engineer; Post-Graduate Student


Read the full article 

Abstract. The problem of modeling the process of machining in CAE-systems is considered. A method of cutting force determining based on the cutting theory postulates is justified.
Keywords: cutting force, the machining, deformation, system of engineering analysis