DOI 10.17586/0021-3454-2016-59-8-619-624
UDC 621.833.15
PROBABILISTIC METHOD FOR CALCULATION OF PRECISION PARAMETERS OF INVOLUTE CYLINDRICAL GEAR
ITMO University, Department of Mechatronics; senior lecturer
Read the full article
Abstract. Application of a probabilistic method for calculating the precision parameters of involute cylindrical gear is considered. The parameters in question are mounting radial runout and kinematic error of the gear, Monte Carlo method is taken for the probabilistic calculation method.
Keywords: gear wheel, gear, precision, multi-link mechanism, Monte Carlo method, kinematic error
References:
References:
-
ISO 1328-1:1995. Cylindrical Gears – ISO System of Accuracy, Part 1: Definitions and Allowable Values of Deviations Relevant to Corresponding Flanks of Gear Teeth.
-
ISO 1328-2:1997. Cylindrical Gears – ISO System of Accuracy, Part 2: Definitions and Allowable Values of Deviations Relevant to Radial Composite Deviations and Runout Information.
-
ISO 1328–1:2013. Cylindrical Gears – ISO System of Flank Tolerance Classification, Part 1: Definitions and Allowable Values of Deviations Relevant to Flanks of Gear Teeth.
-
Sobol' I.M. Metod Monte-Karlo (Monte Carlo Method), Moscow, 1978, 64 р. (in Russ.)
-
Golenko D.I. Modelirovanie i statisticheskiy analiz psevdosluchaynykh chisel na elektronnykh vychislitel'nykh mashinakh (Modeling and the Statistical Analysis of Pseudorandom Numbers on Electronic Computers), Moscow, 1965, 228 р. (in Russ.)
-
Timofeev B.P., Abramchuk M.V. Sb. dokl. kongressa molodykh uchenykh (Proc. of Young Scientists Congress), St. Petersburg, ITMO University, 2013, no. 2, pp. 357–358. (in Russ.)
-
Timofeev B.P., Abramchuk M.V., Smirnov D.S. 11-ya sessiya Mezhdunar. nauch. shkoly, posvyashchennoy pamyati V.P. Bulatova „Fundamental'nye i prikladnye problemy nadezhnosti i diagnostiki mashin i mekhanizmov“ (11th session of International scientific school, devoted to memory of V.P. Bulatov "Fundamental and applied problems of reliability and diagnostics of machines and mechanisms"), Abstracts of Papers, 2013, рр. 331–340. (in Russ.)
-
Kutsokon' V.A. Tochnost' kinematicheskikh tsepey priborov (Accuracy of Kinematic Circuits Devices), Leningrad, 1980, 221 р. (in Russ.)
-
Timofeev B.P., Novikov D.V. Vestnik mashinostroeniya (Bulletin of Mechanical Engineering), 2013, no. 5, pp. 85–87. (in Russ.)
-
Timofeev B.P., Novikov D.V. Standarty i kachestvo (Standards and Quality), 2013, no. 5, pp. 48–52. (in Russ.)
-
Abramchuk M.V. Sovershenstvovanie raschetov parametrov tochnosti zubchatykh koles, zubchatykh peredach i mnogozvennykh zubchatykh mekhanizmov (Improvement of Calculations of Precision Gears, Gears and Gear Multi-Link Mechanisms), Candidate’s thesis, St. Petersburg, 2014. (in Russ.)
