DOI 10.17586/0021-3454-2016-59-8-651-656
UDC 539.3
MODELING OF REINFORCING LAYER OF COMPOSITE PRODUCT WITH PREDETERMINED STRESS STATE
ITMO University; Department of Mechatronics; Post-Graduate Student
A. Y. Kutin
VP Petro In Treid, LLC, Saint Petersburg, 194295, Russian Federation; Software Engineer
Read the full article
Abstract. The problem of identification of stress-strain state of the reinforcing winding for small products from composite materials is considered. An analytical dependence is revealed between the winding layer pressure, from one side, and the yarn tension and a parameter characterizing the rate of winding thickness change, from the other.
Keywords: composite material, circumferential winding, the spiral of Archimedes, yarn tension
References:
References:
-
Mikheev S.V., Stroganov G.B., Romashin A.G. Keramicheskie i kompozitsionnye materialy v aviatsionnoy tekhnike (Ceramic and Composite Materials in the Aircraft Equipment), Moscow, 2002, 276 р. (in Russ.)
-
Kostikov V.I., Varenkov A.N. Sverkhvysokotemperaturnye kompozitsionnye materialy (Superhigh-Temperature Composite Materials), Moscow, 2003, 560 р. (in Russ.)
-
Demkin N.B. Kontaktirovanie sherokhovatykh poverkhnostey (Engagement of Rough Surfaces), Moscow, 1970, 227 р. (in Russ.)
-
Kragel'skiy I.V., Vinogradova I.E. Koeffitsienty treniya (Friction Coefficient), Moscow, 1962, 120 р. (in Russ.)
-
Drozdov Yu.N., Khurshudov A.G., Panin V.I. Friction and Wear, 1991, no. 3(14), pp. 479–486. (in Russ.)
-
Kato К., Adachi К. Wear, 2002, no. 253, pp. 1097–1104.
-
Poser K., Zum Gahr K.-H., Schneider J. Wear, 2005, no. 259, pp. 529–538.
-
Мedvedovski E. Wear, 2001, no. 249, pp. 821–828.
