DOI 10.17586/0021-3454-2018-61-6-549-551
UDC 621.924.93
INVESTIGATION OF TECHNOLOGY OF GEAR CROWNS MANUFACTURING USING ABRASIVE WATER JET EQUIPMENT
ITMO University, Saint Petersburg, 197101, Russian Federation; Professor
P. A. Nikolaev
JSC „Rawenstvo“; Process Engineer
Read the full article
Abstract. The possibility of using waterjet cutting equipment for gear crowns manufacturing is considered. According to performed investigations, water-jet cutting with NC3015S equipment can replace only the roughing. Results of measurements of crowns working surfaces are presented and the accuracy of manufacturing is evaluated.
Keywords: ring gear cutting, hydro-abrasive cutting, roughness parameters, surface microgeometry
References:
References:
- KalashnikovS.N., KalashnikovA.S., KoganG.I. еtal. Proizvodstvo zubchatykh koles: Spravochnik(Production of Cogwheels: Reference Book), Moscow, 1990, 464 р. (in Russ.)
- Tikhonov A.A. Povyshenie effektivnosti protsessa gidroabrazivnoy obrabotki (Increase in Efficiency of Process of Hydroabrasive Processing), Candidate’s thesis, Rostov-na-Donu, 2011, 157 р. (in Russ.)
- Balashov O.E., Barzov A.A., Galinovskiy A.L. еt al. Ul'trastruynaya tekhnologiya polucheniya mikrosuspenziy (Ultrajet Technology of Receiving Microsuspensions), Bauman Moscow State Technical University, 2011, 352 р. (in Russ.)
